ASTM C Standard Specification for Mineral Fiber Thermal Insulating Cement . This standard is issued under the fixed designation C ; the number immediately 1 This specification is under the jurisdiction of ASTM Committee C on. Buy ASTM C R SPECIFICATION FOR MINERAL FIBER THERMAL INSULATING CEMENT from SAI Global.

This abstract is a brief summary of the referenced standard.

ASTM C - 07() Standard Specification for Mineral Fiber Thermal Insulating Cement

This specification covers mineral fiber thermal insulating materials in the form of dry cement, which, when mixed with a suitable proportion of water, applied as a plastic mass, and dried in place, affords resistance to heat transmission on surfaces operating at a certain range of temperature. This standard does not purport to c1195 all of the safety concerns, if any, associated with its use.

Historical Version s - view previous versions of standard. Note 1 — Precautionary measures should be taken with this material as with other hydraulic-setting mixtures.

It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Historical Version s - view previous versions of standard. This specification covers mineral fiber rock or slag insulating and finishing cement shipped in dry-mix form, including hydraulic-setting binder, which, when mixed with water and applied in accordance with the manufacturer’s directions, affords a smooth surface as a final finish for heated surfaces for specific applications.

Specimens shall be sampled, prepared, tested, and conform accordingly to the following properties: Link to Active This link will always route to the current Active version of the standard. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.

Mineral fiber thermal insulating cement shall be composed of mineral fiber and inorganic fillers, with a suitable proportion of heat-resistant binder. This standard c159 not purport to address all of the safety concerns, if any, associated with its use. This abstract is a brief summary of the referenced standard. The mineral fiber shall consist of rock, slag, or glass processed from a molten state into fibrous form.

The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application.

ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date. Link to Active This link will always route to the current Active version of the standard. The user shall establish appropriate safety and health practices and determine the applicability of regulatory requirements prior to use. It is informational only and not c1195 official part of the standard; the full text of the standard itself must be referred to for its use and application.

ASTM C195 - 07(2013)

It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Different test methods shall be performed in order to determine wstm following properties of the cement: This material should be used within the time period recommended by the manufacturer.

The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard.

Asbestos shall not 1c95 used as an ingredient or component part of the product. Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard. The actual temperature limit shall be agreed upon between the purchaser and the manufacturer.