Autotrol i Manual - Free download as PDF File .pdf), Text File .txt) or read online for free. Valve Exploded View. Valve Parts List. Performa Exploded View. Performa Parts List. Logix Series Controllers Parts List. TROUBLESHOOTING. SWT’s online PDF library of Autotrol Control Valve Installation, Operation, Logix Operation Manual (Models: Twin Alternating, Twin.

I have an Autotrolthe problem I am having is it is not drawing brine in fact during the brine cycle it flows a small amount of water into the brine tank instead of creating the suction needed to draw brine out of the tank.

Autotrol User Manuals | Water Softeners Filters

Thanks for all the helpful advice. If the ball doesn’t seal against its seat you may get water into the salt tank. So I will get a rebuild kit and try that. Can you hear the valve move if you shake the valve body?

It sounds like there is leakage past the 2 and possibly the 3 flapper valves and these are the two main valves. I remember seeing it in the old manuals where it showed a check valve but no real clear way to get to it.

It sounds as if you need a set of new flapper valves, especially the brine pair. Originally Posted by kpreilly. I also xutotrol an Autotrol - and the brine tank is consistently overfilling. What kind of water quality are you deal with? With all of the flappers and other parts off one might be able to by soaking it in some thing like iron out.

Any advice would be greatly appreciated!

Autotrol / Osmonics Manuals

All times are GMT The Autotrol part number of ATthe valve body that sets on top of the tank adapter manuwl looks to be around The air nanual is where the brine line going to the salt tank is connected to the control valve on top the air check. I will let you know the results, thanks. In what area is the check valve and is there anything that it can be soaked in to clean it out like Iron out. Autotrol won’t draw brine Printable View.

While looking at the parts brake down of that valve, I see that there are some O rings between the two parts. I will have to check one of the valves that I have in the pile, see what it sounds like. After putting it back together and installing it back on the tank it still won’t siphon brine and actually water comes out of the brine well tube.

I have taken the control valve off numerous times, disassembled it and cleaned it as best I can. I replaced all the flapper valves and everything works fine now. The only “check valve” is the black rubber autotrpl in the air check on the ajtotrol side facing the control.

If I need one do you have a valve that can be rebilt, or how much is a new valve without the timer. I’ve cleaned the little screen and the injector - and I’ve cleaned the air check valve base. The time now is I’ve never seen a bad ball.

There is no check valve anywhere inside the Autotrol I have a steady, but slow stream of water little more than a trickle coming through the drain line.

When it is free anyway.

Autotrol User Manuals

I sutotrol was going to buy a rebuild kit but don’t want to waste the money if I need to replace the valve assembly. My main problem is iron, I thought about soaking it in a heavy concentrate of super iron out for a couple of days.

You don’t need any new module etc.

Is there anything inside the valve that I cannot get to that might be clogged or stuck and if so what can I do about it? Yes I agree, I disassembled autottol valve, again, and soaked everything in a concentrated solution of Iron out autotol it is clean. I have soaked it in Iron out, flushed it, cleaned the flapper valves, screen, injector valve basically everything that can come apart has come apart and been cleaned.