Some of the features described in this manual may required additional parts and/ or labor, and may not be included as part of the standard installation of this unit. two way start engine Eaglemaster E8. of your home or office. Suitable for cars with diesel and petrol engines, for cars with manual and automatic transmission. E8. IMPORTANT: Please read the entire manual for complete details on the features, accessories and operation before attempting to use your security system.
Author: | Voodoorr Yozilkree |
Country: | Cayman Islands |
Language: | English (Spanish) |
Genre: | Travel |
Published (Last): | 15 April 2024 |
Pages: | 24 |
PDF File Size: | 11.40 Mb |
ePub File Size: | 6.89 Mb |
ISBN: | 833-8-86060-676-9 |
Downloads: | 4800 |
Price: | Free* [*Free Regsitration Required] |
Uploader: | Tosho |
Page of 45 Go.
Eaglemaster E8, car alarm systems | A |
Clock time adjust mode Press over 2sec. Press the button within 5sec. Press button Once again, within 5sec. Please read the entire manual for complete details on the features, accessories and. If PIN code correct insertthe siren will give 1 long chirp to acknowledging that the system is ready for programming of new PIN code, see next step eahlemaster. Clock time engine start mode.
Page 31 Control of the CH-4 2nd stage door unlock If you select this function the stage-by-stage unlocking of driver’s then passengers’ doors one after another is automatically carried out with the remote transmitter if you sequentially press the disarming button. The call can be made by the second person being in the car and enabling the call button on the module of the antenna pager. LED mode indicates the following different triggering. One 5-button 2-way LCD remote transmitter.
Dual Stage Shock Sensor - Dual stage shock sensor: To exit the mznual, simply press the buttons until zzzz icon turn off. This makes it possible to warm up the engine Table-3 of NO.
Please read the entire manual for complete details on the features, accessories and operation before attempting to use your security system. Some of modern skilled car hijackers use the devices known as code grabbers allowing to accept and keep a signal transferred by the remote control of the car security system.
Allows a vehicles engine to active without physical contact from the user. Standard features - To ARM the system: The system supports in memory up to four codes of remotes irrespective of the fact if the codes of four different remotes or the same code four times is recorded into the system.
The system maual be immediately armedand siren turned on and the parking lights will start flashing for 30 seconds. Eaglemaster E8 instrukcija Download 2.
Eaglemaster E8 User Manual
If the system turned on Anti-hI-Jack mode, the parking lights will flash 1 time and manjal LED will start flashing fast indicate that the mode is turned on. Zone2 1st stage sensor triggered. Page 17 - Alarm cycle: Programming of codes for new transmitters Important Please notice that during the programming of a new transmitter into the system memory all previous programmed codes of the transmitters will be erased so in case of programming for additional transmitters the available transmitters shall be programmed again.
Be the first to write your review! E8 control module, five button two way LCD transceiver, four button one way transmitter, dual stage shock sensor, glass mount antenna with dual sided adhesive pad, SPDT relay for starter interrupt, valet over-ride switch, status LED, set of wire harness, owners guide.
While proceed at 60sec. This can be used to pulse the disarm wire of the vehicle’s factory anti-theft device. Page 8 Remote Function Table: Engine running mode Enable ,anual range Press once within 5sec. Two way start engine Eaglemaster E8 Reference: If violation still occurs the system, siren and lights will working for 4 or 5 cycles then the system reset itself and continues to protect other zones.
Eaglemaster E8, car alarm systems
Check-in range turn ON status. To set clock time engine start the vehicle: New product 2-way, engine start 4-channel vehicle security system. Press the button Once.
Page 10 Programming of codes for new transmitters Important Please notice that during the programming of a new transmitter into the system memory all previous programmed codes of the transmitters will be erased so in case of programming for additional transmitters the available ealgemaster shall be programmed again.
System Installation System Installation: Press the button once. The AHJ icon will turn on after 60sec.